Search results
Jan 31, 2022 · The REGEN load is open or has a short circuit. Measure the REGEN resistors. The Vector drive is defective. Chek the REGEN circuit at the vector drive. There is a problem with the incoming AC power. Measure the incoming AC Power. The REGEN elements glow red/overheat when the machine is idle, and the servos are enabled.
- Vector Drive - Troubleshooting Guide - NGC - Haas Automation Inc.
Alarm 647 REGEN LOAD SHORTED: There is a problem with the...
- REGEN, 5.6 OHM 4 COIL RESISTORS | Regen - Haas Automation
Haas Parts Your source for genuine OEM Haas parts. The...
- Vector Drive - Troubleshooting Guide - NGC - Haas Automation Inc.
haas on twitter haas on instagram 👋 @ SenSchumer @ SpeakerPelosi @ McConnellPress @ GOPLeader , American horses are being slaughtered across our borders e…
About Me. I’m Haas. I was born in Tulsa, Oklahoma, and lived there until I was six years old. Since that time, I have been fortunate to call many places “home.”. An only child, I grew up in Marietta, Georgia, and spent the majority of my early years swimming inside my own head, imagining far-off places and drawing maps of how I’d get there.
• Remove the spindle drive and the regen resistor assembly. When retrofitting a 20HP machine, remove the brake unit. Figure A shows a control cabinet before retrofit. • Install the Haas vector drive, regen box, and all the cables specified in each BOM. • Check and set the parameters. Vector Drive - Upgrade -Installation
Nov 1, 2007 · servo and spindle drive regen load resistors. this morning i turned on one our vfoe only to discover within 5 mins the servo and spindle drive regen load resistors were glowing red i turned off the machine pulled the fuses not had time to look at the fault yet but welcome some ideas as to what caused this. thanks in advance for any ideas.
