Search results
Heading Sensor Calibration The Heading Sensor calibration is initiated using either the i-Pilot or i-Pilot Link remote. Refer to the Owner’s Manual for your motor if you are unsure of the i-Pilot system that comes with your motor. The process of calibrating the Heading Sensor must occur while your boat is on the water.
- Specifications
Page 1 Product Release boatinglifestyleadventure LINK • New...
- Installation Manual
Page 7 Link Controller and the en- (Figure 16) AutoPilot...
- Specifications
Oct 17, 2023 · The GPS Signal Strength icon may not always show 4 bars. GPS signal strength is impacted by many influencers, including: i-Pilot Link controller having a clear view of the sky (especially to the southern sky), boat being located alongside a high bank, and your geographic location. Troubleshooting i-Pilot or i-Pilot Link
People also ask
How do I know if my I-pilot link controller is working?
How do I Pair my I-pilot controller?
How do I connect the I-pilot link controller?
How do I troubleshoot my I-pilot?
Oct 23, 2023 · Legacy i-Pilot displays "F" on the screen If your Legacy i-Pilot Remote shows an "F" on the display, the remote is not able to find the motor. the i-Pilot remote is not able to communicate with the i-Pilot Controller built into the trolling motor. Click here for additional information. Verify the i-Pilot Controller has power.
Oct 17, 2023 · On the device you intend to pair with the i-Pilot controller, turn Bluetooth "on". Locate the Pair button on the top of your Control Head. The Control Head contains the i-Pilot controller. Press and hold the Pair button. The Control Head will emit a continuous tone. While the Pair button is being held down, scan for the motor on your device.
Scroll through the Content Area using your finger or the Screen Navigation button to find the Cruise Control button. Aut Cruise Control. Select the Cruise Control. ecor Cruise Control. button using your finger or by pressing the Ok button. L iT k 3. The Cruise Control target speed will appear in the Dashboard.
1. Remove all power to the trolling motor. Page 10 5. Route the ethernet cable through the grommet hole and through the center of the coil cord. (figure 5) 6. Plug the i-Pilot link controller connector into the accessory connector as shown. (figure 6) be careful to orient connector properly prior to pushing together.
Install new grommet supplied with i-Pilot link by snapping it into 14. Remove center housing by pushing in on both sides and lifting up the hole located in front of the coil cord strain relief. The i-Pilot at the same time. Page 10 15. (figure 32) cable into the open strain relief slot. (figure 29) 17.
